1. Product Introduction

This product is manufactured with advanced technology, adopting high‑quality modified acrylic emulsion as the main film‑forming substance, supplemented by titanium dioxide, calcium carbonate and other premium pigments, fillers and various functional additives. It delivers excellent hiding power, scrub resistance and application performance, and is suitable for decoration and protection of interior walls and ceilings.

1. Product Application

For decoration and protection of interior walls and ceilings.

1. Product Features

◆ Eco‑friendly & Healthy: Odour‑reduced formula with low levels of harmful substances such as VOC and formaldehyde, complying with national environmental protection standards. ◆ High Hiding Power: Effectively covers the base colour of walls with high spreading rate. ◆ Excellent Scrub Resistance: Tough paint film for easy cleaning and maintenance, capable of withstanding repeated daily scrubbing. ◆ Good Workability: Superior levelling property; applicable by brushing, rolling, spraying and other construction methods. ◆ Strong Adhesion: Firmly bonds to the substrate and resists peeling off.

1. Basic Data

1. Condition in Container: No lumps, homogeneous after stirring
2. Application Property: No obstacles for two brush coats
3. Film Appearance: Normal
4. Drying Time (Surface Dry): ≤ 2 hours
5. Contrast Ratio (White / Light‑coloured): ≥ 0.96 (Premium Grade)

1. Application Instructions

5.1 Substrate Preparation

‑ The base surface must be sound, dry, flat, clean, free of loose dust and grease stains. ‑ Wall moisture content shall be less than 10 %, and pH value shall be lower than 10. ‑ Uneven sections should be levelled with putty, sanded smooth and fully cured. New plastered walls are recommended to cure for 4‑8 weeks before painting.

5.2 Application Conditions

‑ Ambient temperature: 5℃‑35℃ is recommended. ‑ Ambient humidity: Relative humidity below 85 %.

5.3 Dilution

‑ Stir thoroughly before use. ‑ Dilute with 0‑20 % clean water depending on application methods. Note: Do not over‑dilute, or paint film performance will be adversely affected.

5.4 Coating System

‑ It is recommended to apply one coat of water‑borne interior alkali‑resistant primer, then apply two coats of this topcoat.

5.5 Application Methods

Brushing, rolling and spraying are acceptable.

5.6 Drying & Recoating Interval (at 25 ℃, 50 % Relative Humidity)

‑ Dry‑to‑touch: approx. 0.5‑1 hour. ‑ Recoating interval: minimum 2‑4 hours.

5.7 Tool Cleaning

‑ Clean tools immediately with clean water upon completion of application.

1. Precautions

• Maintain adequate indoor ventilation during construction and curing period.
• Avoid painting under low‑temperature (<5 ℃) or high‑humidity (>85 %) conditions.
• Keep the product and tools out of reach of children; avoid contact with eyes and skin.
• Do not pour diluted paint back into the original container.

1. Packaging & Storage

Packaging Specification: 20 kg Shelf‑life: 12 months when hermetically stored in cool, dry and ventilated environment at 5‑35 ℃. Storage Requirement: Protect from frost and direct sunlight.

Disclaimer

Information contained in this technical sheet is based on the best and most accurate data available to us at present. Since usage conditions are beyond our control, this information shall not constitute a warranty. Our liability is limited to product selection itself. Product specifications may be updated continuously as products and manufacturing processes are improved. All information shall be subject to our latest confirmation. Please verify you are using the latest revision prior to use.