1. Product Introduction

This product is a fast‑drying thermoplastic acrylic aerosol spray paint. It features simple operation and fast drying performance, suitable for surface treatment of various substrates.

1. Product Application

Widely used for marking, repair and decoration of indoor and outdoor substrates including metal, wood, ABS plastic, glass and leather goods.

1. Product Features

• Fine atomization and high ejection rate for material saving
• Full‑bodied paint film, bright colors and abundant color options
• Smooth application and convenient operation
• Excellent adhesion and good durability

1. Basic Specifications

1. Application Instructions

Follow the steps below for optimal results:

• Surface Preparation – Thoroughly remove oil stains, water stains and dust from the spraying area.
• Surface Repair – Fill dents on the substrate with putty and sand to a smooth finish.
• Shake Thoroughly – Shake the can side‑to‑side for about 2 minutes before spraying to fully mix the paint.
• Test Spray – Carry out a small‑area test spray on a test panel. Proceed to large‑area application only after confirming correct color.
• Spraying Technique – Hold the can 15‑25 cm away from the workpiece. Press the nozzle with your index finger and spray in zig‑zag side‑to‑side strokes.
• Multiple Thin Coats – Apply several thin coats with 1‑2 minutes interval between coats. This yields better results than one single heavy coat.
• Residual Paint – If spraying fails, try fitting a new nozzle. If the problem persists, return to your dealer for product replacement.
• Nozzle Cleaning Before Storage – If the can is not fully used up, invert the can and hold down the nozzle for about 3 seconds before storage. This clears residual paint inside the tube and nozzle to prevent clogging.

1. Safety Precautions

• Keep out of reach of children. Keep the can upright at a 45° angle to the horizontal plane during spraying.
• Apply paint in a well‑ventilated area to avoid excessive inhalation of paint mist.
• In case of eye contact, flush eyes immediately with plenty of clean water and seek medical attention. If accidentally swallowed, get medical help right away.
• Store in cool, well‑ventilated place below 45 °C. Do not leave inside vehicles; keep away from heat sources and open flames.
• Do not expose to direct sunlight, puncture or incinerate the can.
• Disclaimer: Our company shall only be liable for compensation for defects of the product itself. We accept no liability for any consequential loss arising from product usage.

1. Disposal of Empty Cans

• Invert the can over old newspaper or a waste bin and press the nozzle for approximately 3 minutes to drain all residual paint.
• Where safe to do so, remove the nozzle and press the can while inverted to completely expel leftover paint.

1. Storage

Notes

Information contained in this technical sheet is based on the best and most accurate data available to us at present. Since usage conditions are beyond our control, this information shall not constitute a warranty. Our liability is limited to the product itself. Product specifications may be updated continuously as products and manufacturing processes are improved. All information shall be subject to our latest confirmation. Please verify you are using the latest revision prior to use.